WarningCommercial Sales AreaWelcome to HappyStim-USAAbout UsVISIT OUR ON-LINE STOREElectro-Layaway PlanCancellation and Return PolicyFax Instructions - Paying By Credit CardPrivacy and other FAQsShipping & Useful InformationTestimonialsLinksReferralsQuestions? Contact UsDisclaimers
    Back 

8mm (5/16") Stainless Steel Insert Tip With Tubing

RECEIVE 1 FOOT OF 8x4MM (5/16"x1/4") CONDUCTIVE TUBING FREE WITH THE PURCHASE OF A STAINLESS STEEL TIP.  

NOTE: The 8mm tips are now more rounded like the tip of a bullet like the 6mm tip you see below.  They are not pointed as the picture shows.

We have three diameter sizes to choose from if a 5/16" diameter is too large.

A 4mm (1/8") or a 6mm (1/4") can also be purchased.  Look for these in the Urethral Insert Section as well.

webassets/SSTipGroup-1.jpg

Now you can make your own urethral inserts simply by purchasing the stainless steel tip. 
Included with this special, you will also receive a one-foot piece of 8x4mm conductive tubing that holds the tip shaft snugly into the inside diameter of the tube.

As with all urethral inserts, be sure that the end of the tubing is straight and flush with the collar of the stainless tip. If the end is not flush, use a razor blade to cut the end perfectly flush.  This assures a good tight fit and will not allow any fluids to get in-between the inside of the tubing and the stainless shaft.  After shoving the tip into the tubing, always tug GENTLY on the tip to make certain that it does not pull off.  Normally, the slight tugging causes the same effect of the old Chinese finger cuffs, causing it to tighten when pulled.  Inspect your insert carefully each time before use to insure that the tip is securely in place.  If the tip is the slightest bit loose or if you can see any portion of the inner-shaft between the collar of the tip and the tubing, DO NOT USE, as this may cause disaster if the tip comes loose and falls off during use.

webassets/8mmTip.jpg

SUGGESTION: Placing a very small drop of Super Glue on the end of the shaft before inserting it into the tubing enhances the ability of the shaft fitting securely inside the tubing.  Never coat the entire shaft with glue, as it acts as an insulator and current will not get directly to the tip.

NOTE: You are making this insert at your own risk.  Because you the buyer, are constructing this insert yourself, we will not and cannot be held liable for any damage, liability or injury caused by constructing or using it. 


Item #8MMSSTIP


Regular price $32.95 

Concerned with placing your order online?  Call or Fax in your order.  Simply call 618-343-4344. If you wish to fax your order to us, please send all pertinent details including your credit card information and a copy of your order.  Thank you.
  Back