NEW Design by me to make hands free orgasms easier to achieve. This one features two loops on the side that can be used to thread a cord or elastic through to hold it firmly against your body.

When using conductive rubber cock loops for stimming you generally only stimulate the dorsal nerves running along the top of the penis. The sensations generated are felt at the glans of the penis. Insulating the top part of a lower cock loop if it is around the cock and balls allows you to stim both the Dorsal and Perineal nerves leading to better sensations.

I have designed a basic 3D printable cock loop insulator and guide for Conductive Rubber Cock Loops. The design is done and it is freely available for download on my site if you have access to a 3D printer so that you can make one yourself.

However, if you do not own a 3D printer then I am offering a service where I will print one out for you and send it to you. Each cock loop insulator will be printed in my trademark YELLOW PLA. This insulator comes with 10″/25cm of 8mm conductive rubber tubing that takes 4mm plugs.

I will also include a small length of 4mm CR that takes 2mm plugs so that it can be used as an adaptor to allow you to use 4mm or 2mm plugs on this one.

Suggestion: Fit the short length of 4mm CR into one end of the loop and then you can use either a 4mm plug or a 2mm one.

It will be dispatched un-painted but with 8mm conductive rubber tubing already fitted.

The inner hole size is 1mm larger than the CR tubing, this 8mm tubing is a good friction fit and you don’t need the plastic locking clamp to keep it in place once fitted. Just slip it over your cock and tighten before plugging your 4mm plug into the CR (or use the included 4mm CR to use a 2mm plug).

Instructions

• If you plan on using cord or elastic then thread it through the loops before fitting the electrode to your body.
• Place the insulated cock loop around your cock and balls with the plastic insulator on top. Use electro-lube to ensure you get good contact between the conductive rubber and your skin.
• Attach a plug to one end of the conductive rubber.
• For the second electrode, I recommend either a cock loop of self-adhesive monopole pad electrode. Place the electrode either on your glans or just under it.
• Attach the second plug to the other electrode.
• Plug your cable into your control box and ensure all power levels knobs are set to zero output.
• Turn on your power box, select your favorite settings and slowly turn up the power.

Tips For Use

• Always use conductive lube with conductive rubber. Never use silicone lube or oil-based products as they are an insulator.
• Silicone lube bonds to conductive rubber and creates an insulating coating on it rendering it un-useable so never use silicone lube.
• Water-based lubes will suffice if you have no electro-gel.
• Cock loops should be a snug fit to allow for swelling of your penis without cutting off the blood supply.

Cleaning

The conductive rubber can be removed for cleaning, wash it in warm soapy water.

Wipe down the insulator with an anti-bacterial wipe. It is recommended that the insulator is painted before use but this is not essential.

Ensure everything is dry before storing away until your next stimming session.