Joanne designed a 3D printable vaginal or anal Monopole Conductive Rubber Electrode that she is calling my Didi. The design is done and is available for download on my Gdrive if you have access to a 3D printer so that you can make one yourself.

  

However, if you do not own a 3D printer then you can order one here.  🙂 Each Didi Electrode will be printed in Joanne’s trademark YELLOW PLA. This insulator comes with 10″/25cm of 6mm conductive rubber tubing that takes 2mm (TENS) pins.

  

It will be dispatched un-painted but with 6mm conductive rubber tubing already fitted unless you opt for an un-assembled one. One side of the Conductive Rubber loop has a pin fitted to secure it in place. Your TENS pin  secures the other end, you can remove this plug to allow two plugs to attach to this electrode from different channels if you are using a Tri-phase set-up to make it the base connector.

Just plug in your 2mm TENS pin and then insert it into your vagina or anus before switching on your control box and experiencing some e-stim pleasure.

Joanne recommends that you paint it first though to seal the surfaces with a plastic paint such as Krylon Fusion For Plastic.

Note: This product is supplied as is and I am not liable for any problems that arise from its use. It is sold as a novelty item and carries no warranty. Your statutory rights remain. Images shown are renderings, the printed product will show some layer lines and require a light sanding.