A great way to use your Venus 2000 for e-stim or for that matter, simply lube the inside with water based lube, pull it on over your shaft and connect a lead wire. Another method would be to just use it in a regular cylinder or in a penis pump cylinder. It’s all good!
Our soft stretchy conductive liner fits most of the ABCO receivers. This material is sold by the foot. If ordering lengths longer than 1 foot it is shipped in one uncut section.
This thin-walled tubing is 1-7/16″ in diameter and is an excellent conductive liner for your V2000 receiver and vacuum penis pumps. It can also be use simply stretched out and placed in an open cylinder to estim. Circumference of this tube is 4.5 inches. It does stretch about 1/2″ or so, but do not try stretching it too much, as it will tear. 🙁
To visually see the size of the opening that this tube makes, simply measure and mark 4.5 inches from the edge of a piece of paper and make a circle out of it. The circumference of the tubing is 4.5″.
We also carry a thicker walled 1.75″ diameter conductive tube. You will find this product in our Cock and Ball and DIY section of the web site.
A fully equipped receiver will look like the one set-up below. This is a single pole set up and requires another electrode placed elsewhere to complete the circuit.
Another version of the Venus 2000 receiver to make a bi-polar circuit can be configured as shown below using our Flat Conductive Rubber connected to the standard Venus 2000 receiver as shown below.
Turn your receiver into a Bi-Polar Electrode
Just order some electrically conductive flat material and a power box if you don’t already have them. Both, the Flat Clips and the 3/4″ conductive silicone flat strip can be found in the Wiring and Adapter section and Conductive Silicone Tubing sections of the web site respectively.
It will usually take about a yard of our Flat Conductive Rubber and two Flat Clips to achieve this set-up.
Only logged in customers who have purchased this product may leave a review.
Reviews
There are no reviews yet.