Looking for a way to make your own splitter from existing wires or to make your own?  These connectors make it easy to do.  Just strip off a small bit of the insulation from a wire, open the clip, insert the wire and just push it down until it snaps.  Holds wires securely in place and non-exposed.  If you want to place TENS pins  on the end of each wire, you can also do that by getting our pre-connected pins on single wires or just use your lead wire TENS pins.

Three Wire                                                       Four Wire

This illustration (above) shows a stripped down 8 gage wire connected to one side of a two-wire snap connector.