Double Electrode Rooster Booster Special
Get two of my popular electrodes together with a nice discount.
My bipolar glans electrode with stainless steel focussing balls together with my new insulated cock loop. Great for
Triphase play, these popular electrodes provide some fantastic sensations.
Both take 2mm plugs and are a combination of 4mm and 6mm high-quality conductive
rubber together with 3D printed components in my bumblebee look yellow PLA.
They will be dispatched un-painted and un-finished, so you may need to give it
a light sanding to remove any pieces of the support structure that is printed in place by the 3D printer. This takes no time
at all and then it is ready for use.
The inner holes are sized for 6mm and 4mm CR tube size and it will be supplied
with the 6mm CR fitted in place with the 4mm loop ready for assembly. If I ship them assembled, then there is a chance of
the 4mm CR being damaged in transit.
Instructions
• Place the insulated cock loop around your cock and balls with the plastic insulator on top. Use electrolube
to ensure you get good contact between the conductive rubber and your skin with both electrodes.
• Attach a plug to one end of the conductive rubber.
• The glans electrode is bipolar and can be used on its own or you can opt for which piece of conductive rubber
you plug into. Adjust for a snug fit.
• Attach the second
plug to the other electrode.
• Plug your cable into your
control box and ensure all power levels knobs are set to zero output.
•
Turn on your power box, select your favourite settings and slowly turn up the power.
Tips For Use
• Always use conductive lube with conductive
rubber. Never use silicone lube or oil-based products as they are an insulator.
• Silicone lube bonds to conductive rubber and creates an insulating coating on it rendering it unuseable so
never use silicone lube.
• Water-based lubes will suffice
if you have no electrogel.
• Cock loops should be a snug
fit to allow for swelling of your penis without cutting off the blood supply.
Cleaning
The conductive rubber can be removed for cleaning,
wash it in warm soapy water.
Wipe down the insulator with an anti-bacterial
wipe. It is recommended that the insulator is painted before use but this is not essential.
Ensure everything is dry before storing away until your next stimming session.
